ISO 10931-5:1998 pdf free download.Plastics piping systems for industrial applications — PoIy(vinylidene fluoride) (PVDF) — Part 5: Fitness for purpose of the system.
This part of ISO 10931 specifies the requirements for the fitness for purpose of piping systems made from poly(vinylidene fluoride) (PVDF) for industrial applications, i.e. the conveyance of water and chemicals in the liquid or gaseous state. It also specifies the test parameters for the test methods referred to in this part of ISO 10931.
It is applicable to PVDF assemblies for the conveyance of fluids under pressure at temperatures up to 150 CC. However, applications above 120 CC, which depend on the crystalline melting point of the PVDF material1 need to verified with the suppliers of the components.
NOTE — For information on the resistance of PVDF materials in contact with chemicals, see ISO/TR 10358:1993, Plastics pipes and fittings — Combined chemical-resistance classification table.
2 Normative references
The following standards contain provisions which, through reference in this text, constitute provisions of this part of ISO 10931. At the time of publication, the editions indicated were valid. All standards are subject to revision, and parties to agreements based on this part of ISO 10931 are encouraged to investigate the possibility of applying the most recent editions of the standards indicated below. Members of IEC and ISO maintain registers of currently valid International Standards.
ISO 1167:1996, Thermoplastics pipes for the conveyance of fluids — Resistance to internal pressure — Test method.
ISO 3458:1976, Assembled joints between fittings and polyethylene (PE) pressure pipes — Test of leakproofness under internal pressure.
ISO 3459:1976, Polyethylene (PE) pressure pipes — Joints assembled with mechanical fittings — Internal under- pressure test method and requirements.
ISO 10931-1:1997, Plastics piping systems for industrial applications — Poly(vinylidene fluoride) (PVDF) — Part 1:
General.
3 Definitions
For the purposes of this part of ISO 10931. the definitions, symbols and abbreviations given in ISO I 0931-1 apply.
4 Fitness for purpose of assembly
When tested in accordance with the test methods specified in table 1 or 2, as applicable, using the parameters indicated, the assembly shall conform to the requirements specified.
ISO 10931-5:1998 pdf free download
Note:
If you can share this website on your Facebook,Twitter or others,I will share more.