ISO 582:1995 pdf free download.Rolling bearings Chamfer dimensions – Maximum values.
1 Scope
ISO 582 specifies the maximum chamfer dimensions of metric series rolling bearings, for which boundary dimensions, including chamfer minimum dimensions, are given in other International Standards Requirements fo the maximum dimensions of the corresponding shaft and housing fiflet Iddli ure &so given.
It does not apply to chamfers, for which dimensions are not specified, or for which other dimensions are specified in other International Standards.
2 Normative references
The following standards contain provisions which. through reference in this text, constitute provisions of ISO 582. At the time of publication, the editions indicated were valid All standards are subject to revision, and parties to agreements based on ISO 582 are encouraged to investigate the possibility of applying the most recent editions of the standards indicated below. Members of IEC and ISO maintain registers of currently valid International Standards.
ISO 15:1981, Rolling bearings — Radial bearings — Boundary dimensions — General plan.
ISO 104:1994, Rolling bearings — Thrust bearings — Boundary dimensions, general plan.
ISO 246:1995. Rolling bearings — Cylindrical ,uller bearings, separate thrust collars — Boundary dimensions.
ISO 355:1977, Rallmg bearings — Metric tapered roller bearings — Boundary dimensions and series designa tions.
ISO 464:1995, Rolling bearings — Radial bearings with locating snap ring — Dimensions and tolerances.
ISO 12043:1995, Rolling bearings — Single-row cylindrical roller bearings — Chamfer dimensions for loose-rib and non-rib sides.
ISO 12044:1995, Rolling bearings — Single-row angular contact ball bearings — Chamfer dimensions for outer ring non-thrust side
3 Definitions
For the purposes of ISO 582, the following definitions apply.
3.1 radial direction chamfer dimension (of a bearing ring or washer): The distance between the imaginary sharp ring or washer corner and the intersection of the chamfer surface and the ring or washer face.
3.2 axial direction chamfer dimension (of a bearing ring or washer): The distance between the imagiriary sharp ring or washer corner and the intersection of the chamfer surface and the bore or outside cylindrical surface of the ring or washer.
4 Symbols and dimensions
See figure 1 and tables 1 to 5.
The dimensions given in tables 1 to 5 corresponding to symbols shown in figuro 1 aro nominal dimonsions unless specified otherwise.
5 Shaft and housing fillet radii
The largest permissible single shaft and housing fillet radius should not exceed the smallest permissibic singlc chomfor dimonsion of the corresponding ring or washer rs min or r1s min.